Rohde & Schwarz R&S SMB100B - Page 88

Analog modulations
R&S
®
SMB100B
88User Manual 1178.3711.02 ─ 08
Pulse Delay...................................................................................................................90
Double Pulse Delay.......................................................................................................90
Pulse Output State........................................................................................................90
Show Connector............................................................................................................90
Pulse Output Polarity.................................................................................................... 90
Execute Single Trigger..................................................................................................90
Pulse Sync Out............................................................................................................. 90
Pulse Mode
Sets the operating mode of the pulse generator. Depending on the selection, the instru-
ment displays the associated parameters.
"Single"
Generates a single pulse in one pulse period.
1 = Pulse delay
2 = Pulse width
3 = Pulse period
"Double"
Generates two pulses in one pulse period.
1 = Pulse width
2 = Double pulse delay
3 = Double pulse width
4 = Pulse period
Modulation settings