Remote Control Commands
R&S
®
SMB100A
426Operating Manual 1407.0806.32 ─ 13
STEReo:DIRect "PRE=<Preemphasis>"
STEReo:DIRect? "PRE"
(for documentation reasons only)
Sets one of various preemphasis options.
Use the SCPI commands [:SOURce]:STEReo:AUDio:PREemphasis:STATe and
[:SOURce]:STEReo:AUDio:PREemphasis instead.
Setting parameters:
<Preemphasis> 0 | 1 | 2
0
Off
1
50 us
2
75 us
Example:
STEReo:DIRect "PRE=1"
The preemphasis is set to 50 us.
Example:
STEReo:DIRect? "PRE"
Response: "1"
STEReo:DIRect "PRESET"
Sets the default settings in accordance with specifications.
Example:
STEReo:DIRect "PRESET"
Usage: Event
STEReo:DIRect "PS=<PS>"
STEReo:DIRect? "PS"
Sets or reads the RDS program service (PS) name.
Setting parameters:
<PS> 8 ASCII characters
Note: An eight-digit value must always be set. Blank spaces, if
any, must also be entered, otherwise the value will not be accep-
ted.
Special characters in the program service name are entered with
a leading back slash (\) followed by the decimal code of the spezial
character according to tabe E1 of CENELEC.
Example: STER:DIR "RT=02,0,test text with \217" 217
denotes the German ü.
Example:
STEReo:DIRect "PS=RDS Test"
Sets the program service name to be transmitted to "RDS Test".
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
To Next Page
Loading...
