9. SNMP
ROX™ v2.2 User Guide 104 RuggedBackbone™ RX5000
The SNMP agent will also listen on these IP Addresses:Port values. Add ':#' to set non-default port
value #. (ie. xxx.xxx.xxx.xxx:19343 [::] [::]:16000)
Maximum Number of SNMP Sessions
Synopsis: unsigned integer
Synopsis: - the keyword { unbounded }
Default: 30
The maximum number of concurrent SNMP sessions
SNMP Local Engine ID
Synopsis: A string
Provides specific identification for the engine/device. By default, this value is set to use the base
MAC address within the Engine ID value.
When using SNMP v3: if you change this value, you must also change the User SNMP Engine ID
value for SNMP users.
Source IP for Traps
Synopsis: IPv4 address in dotted-decimal notation
Synopsis: IPv6 address in colon-separated hexadecimal notation
If set, all traffic/traps originating from this device shall use the configured IP Address for the Source
IP
Authentication Failure Notify Name
Synopsis: string - one of the following keywords { snmpv3_inform, snmpv3_trap,
snmpv2_inform, snmpv2_trap, snmpv1_trap, none }
Default: none
When the SNMP agent sends the standard authenticationFailure notification, it is delivered to
the management targets defined for the snmpNotifyName in the snmpNotifyTable in SNMP-
NOTIFICATION-MIB (RFC3413). If authenticationFailureNotifyName is the empty string (default),
the notification is delivered to all management targets.
Enable Authentication Traps
Synopsis: boolean
Default: false
Enables authentication traps to be sent from the SNMP agent.
DSCP Value for SNMP Traffic
Synopsis: unsigned byte integer in the range [0 to 63]
Default:
Support for setting the Differentiated Services Code Point (6 bits) for traffic originating from the
SNMP agent.
To Next Page
Loading...
Need help?
General
