30. Tunnelling
ROX™ v2.2 User Guide 305 RuggedBackbone™ RX5000
30.1.2. IPsec Configuration
Figure 30.2. IPsec menu
The IPsec menu is accessible from the main menu under tunnel. The path to this menu is tunnel/ipsec.
The IPsec form appears on the same screen as the IPsec menu.
Figure 30.3. IPsec form
The IPsec form is used in configuring IPSec VPN.
Enable IPSec
Enables IPSec.
NAT Traversal
Enables NAT Traversal.
Keep Alive
Synopsis: unsigned integer
The delay (in seconds) for sending keepalive packets to prevent NAT router from closing its port
when there is not enough traffic on the IPsec connection.
Figure 30.4. Syslog form
The path to the Syslog form is tunnel/ipsec.
To Next Page
Loading...
