EasyManua.ls Logo

RuggedCom RUGGEDBACKBONE RX5000 - STFP Sessions Form

RuggedCom RUGGEDBACKBONE RX5000
440 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. System Administration
ROX™ v2.2 User Guide 40 RuggedBackbone™ RX5000
Figure 2.17. STFP Sessions form
The SFTP Sessions form sets the parameters for Secure File Transfer Protocol (SFTP) sessions.
enabled
Synopsis: boolean
Default: false
Enable/Disable the SFTP user interface
Listen IP
Synopsis: IPv4 address in dotted-decimal notation
Synopsis: IPv6 address in colon-separated hexadecimal notation
Default: 0.0.0.0
The IP Address the SFTP will listen on for SFTP requests (default 0.0.0.0).
Listen Port
Synopsis: unsigned short integer
Default: 2222
The port the SFTP will listen on for SFTP requests (default 2222).
Extra IP:Ports
Synopsis: A string
Synopsis: "extra-ip-ports" occurs in an array.
The SFTP will also listen on these IP Addresses:Port values. Add ':#' to set non-default port value
#. (ie. xxx.xxx.xxx.xxx:19343 [::] [::]:16000)
Maximum Number of SFTP Sessions
Synopsis: unsigned integer
Synopsis: - the keyword { unbounded }
Default: 10
The maximum number of concurrent SFTP sessions

Table of Contents

Other manuals for RuggedCom RUGGEDBACKBONE RX5000

Related product manuals