EasyManua.ls Logo

RuggedCom RUGGEDBACKBONE RX5000 - Configuring DHCP Server; Enabling the DHCP Service; DHCP Interfaces

RuggedCom RUGGEDBACKBONE RX5000
440 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15. DHCP Server
ROX™ v2.2 User Guide 141 RuggedBackbone™ RX5000
15.2. Configuring DHCP Server
The DHCP Server menu is available under services at services/dhcpserver.
Figure 15.1. DHCP Server menu
Under services/dhcpserver, you can configure the following:
enable the DHCP service. See Section 15.2.1, “Enabling the DHCP Service”.
set the interface. See Section 15.2.2, “DHCP Interfaces”.
configure subnets and pools. See Section 15.2.3, “DHCP Subnets and Pools”.
configure shared networks. See Section 15.2.4, “DHCP Shared Networks”.
configure hosts. See Section 15.2.5, “DHCP Hosts”.
configure host-groups. See Section 15.2.6, “DHCP Host-groups”.
configure DHCP options. See Section 15.2.8, “DHCP Options”.
Under services/dhcpserver, you can also view a list of active DHCP leases. See Section 15.2.7, “Viewing
Active DHCP Leases”.
15.2.1. Enabling the DHCP Service
To enable or disable the DHCP service, navigate to services/dhcpserver. On the Dynamic Host Control
Protocol (DHCP) server form, enable or disable the DHCP service.
Figure 15.2. DHCP Server form
enabled
Enables and disables the the DHCP server.
15.2.2. DHCP Interfaces
A DHCP listen interface is the interface on which DHCP listens for lease requests. You can configure
multiple DHCP interfaces.
To view a list of DHCP listen interfaces, navigate to services/dhcpserver/interface.

Table of Contents

Other manuals for RuggedCom RUGGEDBACKBONE RX5000

Related product manuals