36. Traffic Control
ROX™ v2.2 User Guide 399 RuggedBackbone™ RX5000
unique integer between 1-255. Each class must have its own unique mark.
min-bandwidth
Synopsis: string
The minimum bandwidth this class should get,
when the traffic load rise... This can be
either a numeric value or a calculated expression
based on the bandwidth of the interface. A
fixed numerical value must only be a number -
its unit is specified in Minbw-unit.
A calculated expression is based on a fraction of the
'full' bandwidth, such as:
'full/3' for a third of the bandwidth and
'full*9/10' for nine tenths of the bandwidth.
In such a case, do not specify any Minbw-unit
minbw-unit
Synopsis: string - one of the following keywords { none, bps, mbps, mbit, kbps, kbit }
Default: none
(kbps, mbps...) Only if min-bandwidth is a single numerical value
max-bandwidth
Synopsis: string
The maximum bandwidth this class is allowed to use
when the link is idle... This can be either a numeric
value or a calculated expression based on the bandwidth
of the interface. A fixed numerical value must only be
a number - its unit is specified in Maxbw-unit.
A calculated expression is based on a fraction of the
'full' bandwidth, such as:
'full/3' for a third of the bandwidth and
'full*9/10' for nine tenths of the bandwidth.
In such a case, do not specify any Maxbw-unit
maxbw-unit
Synopsis: string - one of the following keywords { none, bps, mbps, mbit, kbps, kbit }
Default: none
(kbps, mbps...) Only if max-bandwidth is a single numerical value
priority
Synopsis: unsigned short integer
Default:
The priority in which classes will be serviced... Higher priority
classes will experience less delay since they are serviced
first. Priority values are serviced in ascending order
(e.g. 0 is higher priority than 1).
To Next Page
Loading...
