RuggedCom RUGGEDBACKBONE RX5000 User Manual

5. IP Network Interfaces
ROX™ v2.2 User Guide 83 RuggedBackbone™ RX5000
Synopsis: string - one of the following keywords { lm6, lm5, lm4, lm3, lm2, lm1, sm }
The name of the module location provided on the silkscreen across the top of the device.
Port
Synopsis: integer
The port number as seen on the front plate silkscreen of the switch (or a list of ports, if aggregated
in a port trunk).
Enabled
Synopsis: boolean
Default: true
Enables/Disables the network communications on this port
AutoN
Enables or disables IEEE 802.3 auto-negotiation. Enabling auto-negotiation results in speed and
duplex being negotiated upon link detection; both end devices must be auto-negotiation compliant
for the best possible results
Speed
Synopsis: string - one of the following keywords { 1000, 100, 10 }
Speed (in Megabit-per-second or Gigabit-per-second). If auto-negotiation is enabled, this is the
speed capability advertised by the auto-negotiation process. If auto-negotiation is disabled, the port
is explicitly forced to this speed mode. AUTO means advertise all supported speed modes.
Duplex
Synopsis: string - one of the following keywords { full, half }
If auto-negotiation is enabled, this is the duplex capability advertised by the auto-negotiation
process. If auto-negotiation is disabled, the port is explicitly forced to this duplex mode. AUTO
means advertise all supported duplex modes.
link-alarms
Synopsis: boolean
Default: true
Disabling link-alarms will prevent alarms and LinkUp and LinkDown SNMP traps from being sent
for that interface. Link alarms may also be controlled for the whole system under admin / alarm-cfg.
IP Address Source
Synopsis: string - one of the following keywords { dynamic, static }
Default: static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. Option DYNAMIC
is a common case of dynamically assigned IP address. It switches between BOOTP and DHCP
until it gets the response from the relevant server. Must be static for non-management interfaces
ProxyARP
Enables/Disables whether the port will respond to ARP requests for hosts other than itself
on-demand
This interface is up or down on demand of link fail over.
alias
Synopsis: A string
The SNMP alias name of the interface

RuggedCom RUGGEDBACKBONE RX5000 Specifications

General

Brand	RuggedCom
Model	RUGGEDBACKBONE RX5000
Category	Switch
Language	English