Safran VersaSync - Dis-;Enabling NTP

Expert Mode: Turning this switch ON enables direct access to the NTP.conf
file, thus bypassing the VersaSync Web UI. [Default =OFF] See "NTP
Expert Mode" on page135.
Note: Safran Tech Support does not support the editing of the
NTP configuration files in Expert Mode. For additional inform-
ation on editing the NTP.conf file, please refer to
http://www.ntp.org.
Other NTP Services that can be configured via the NTP Services panel by clicking
the GEAR icon are:
Stratum 1 (see "NTP Reference Configuration" on page115)
The NTP Status Summary panel
… provides a real-time overview of your key NTP network parameters. For more
information, see "NTP Status Monitoring" on page274.
2.8.11.3 Dis-/Enabling NTP
If you applied NTP configuration changes e.g., added a new NTP Server, Ver-
saSync usually will stop and re-start the NTP Service automatically once you
clicked Submit. Changes made to NTP configurations will also take effect after
VersaSync is either rebooted or power-cycled.
You can, however, also disable or enable the VersaSync NTP Service manually,
e.g. with NTP Autokey.
To disable and enable your NTP Service:
1. Navigate to MANAGEMENT > NETWORK: NTP Setup.
2. In the NTP Services panel, set the ON/OFF toggle switch to OFF.
112
CHAPTER 2 • VersaSync User Manual Rev. 12
2.8 Configuring Network Settings