Safran VersaSync - Mounting; Selecting a Mounting Location

5. Establish a network connection so as to allow access to the web user inter-
face ("Web UI"). See "Initial Network Setup" on page34 for information on
the USB driver installation and network address configuration.
Note: You can also use Zeroconf to access the Web UI (see
"Zero Configuration Setup" on page39).
6. Using the Web UI, configure the following:
Software-configurable I/O pins, see "Assigning I/O Pins" on page44.
Other VersaSync INTERFACES settings and MANAGEMENT settings
e.g., network settings, reference priorities (see "Configuring Network
Settings" on page70).
2.2.2 Mounting
2.2.2.1 Selecting a Mounting Location
The unit is to be mounted on a plate, using six (6) through holes. The mounting
location must offer sufficient space to accommodate the unit and the cable con-
nectors, and it must be within cable reach to other connected devices, such as
the GNSS antenna. The unit can be mounted horizontally, or at any angle. The
chosen environment must not fall below IP 65 ingress protection standards.
32
CHAPTER 2 • VersaSync User Manual Rev. 12
2.2 Installation Overview