Perform an SFTP file transfer to the device using Account Password
authentication.
sftp spadmin@10.10.200.5
spadmin@10.10.200.135's password: admin123
You will be presented with the SFTP prompt allowing interactive file transfer and
directory navigation.
Perform an SFTP file transfer to the device using Public Key with
Passphrase authentication
sftp -i ./id_rsa spadmin@10.10.200.5
Enter passphrase for key './id_rsa': mysecretpassphrase
You will be presented with the SFTP prompt allowing interactive file transfer and
directory navigation.
Recommended SSH Client Tools
Safran does not make any recommendations for specific SSH clients, SCP clients,
or SFTP client tools. However, there are many SSH based tools available to the
user at low cost or free.
Two good, free examples of SSH tool suites are the command line based tool
OpenSSH running on a Linux or OpenBSD x86 platform and the SSH tool suite
PuTTY.
The OpenSSH tool suite in source code form is freely available at
www.openssh.org though you must also provide an OpenSSL library, which can
be found at www.openssl.org.
PuTTY can be found at: http://www.chiark.greenend.org.uk/~sgtatham/putty/.
SSH Timeout
The keep-SSH alive timeout is configurable, in seconds, between 0 and 36000
seconds (10 hours). The default is set to 60 minutes (3600 seconds).
2.8.8 SNMP
SNMP (Simple Network Management Protocol) is a widely used application-layer
protocol for managing and monitoring network elements. It has been defined by
the Internet Architecture Board under RFC- 1157 for exchanging management
information between network devices, and is part of the TCP/IP protocol.
96
CHAPTER 2 • VersaSync User Manual Rev. 12
2.8 Configuring Network Settings
To Next Page
Loading...
