Safran VersaSync - Restoring the Factory Defaults; Default and Recommended Configurations

3. Click OK in the grey confirmation window. The system will restore the con-
figuration using the bundled file stored at /home/spec-
tracom/xfer/config/VersaSync.conf, then reboot in order to read the
new configuration file. Once powered back up, VersaSync will be con-
figured with the previously stored file.
4.8.2.5 Restoring the Factory Defaults
For instructions on how to restore the VersaSync's configuration files to their fact-
ory default settings see "Resetting All Configurations to their Factory Defaults"
on page294.
4.8.3 Default and Recommended Configurations
The factory default configuration settings were chosen for ease of initial setup.
However, some of the default settings may deviate from best practices recom-
mendations. The following table outlines the differences between factory default
and recommended configuration settings for your consideration:
Table 4-1:
Default and recommended configurations
Feature Default Setting Recommended Setting
Where to
Configure
HTTP Disabled Disabled WebUI or
CLI
4.8 Resetting the Unit to Factory Configuration
CHAPTER 4 • VersaSync User Manual Rev. 12
299