3. A notification window will confirm the status change.
4. In the NTP Services panel, set the ON/OFF toggle switch to ON again.
Changes made will now take effect and NTP operation will be restored shortly
after this operation is performed.
2.8.11.4 Viewing NTP Clients
To view the NTP clients being served by VersaSync:
1. Navigate to MANAGEMENT> NETWORK: NTP Setup.
2. In the NTP Actions panel, click View NTP Clients:
3. The NTP Clients window will display, showing a table of the clients that are
synchronizing to VersaSync via NTP:
You can search any of the fields for specific information in the Search
field at the top of the window.
A limit of 10 entries will appear on the screen at any one time. If you
have more than 10clients, you can move through the table using the
2.8 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 12
113
To Next Page
Loading...
