will be empty, unless:
a. A leap second is pending, and VersaSync has obtained this inform-
ation automatically from the GPS data stream.
b. A leap second had been configured previously by a user via the Edit
Leap Second window.
2. To access the Edit Leap Second information window, click the GEAR icon
in the Leap Second Information panel.
3. The Edit Leap Second window will display:
4. In the Leap Second Offset field enter the desired GPS Offset.
5. In the Date and Time field, enter the date that the desired leap second
should occur.
6. Click Submit.
To delete a leap second correction, click the Delete button.
Note: The Delete button in the Edit Leap Second window will only
be visible if a leap second has been set beforehand.
3.2.4 Local Clock(s), DST
The Local Clock feature allows for maintaining one or several local times. These
times will reflect a time offset, thereby accounting for Time Zone, and DST (Day-
light Savings Time) correction.
3.2.4.1 Adding a Local Clock
To add a Local Clock:
1. Navigate to MANAGEMENT > OTHER: Time Management.
2. Click the PLUS icon in the Local Clocks panel in the Time Management
screen.
3. The Local Clock pop-up window will display.
4. Enter a Name for your local clock.
The name must be between 1 and 64 characters long; spaces are
allowed.
The name can be any meaningful name that helps you know your
point of reference (for example: “NewYork”, “Paris” or “EasternHQ”,
etc.).
168
CHAPTER 3 • VersaSync User Manual Rev. 12
3.2 System Time
To Next Page
Loading...
