2.1 SAFETY
Table 2-1:
Safety symbols used on this product or in this document
Symbol Signal word Definition
DANGER!
Potentially dangerous situation which may lead to
personal injury or death! Follow the instructions
closely.
CAUTION!
Potential equipment damage or destruction!
Follow the instructions closely.
NOTE
Tips and other useful or important information.
ESD
Risk of Electrostatic Discharge!
Avoid potential equipment damage by following ESD
Best Practices.
CHASSIS GROUND
This symbol is used for identifying the functional
ground of an I/O signal. It is always connected to the
instrument chassis.
Analog Ground
Shows where the protective ground terminal is con-
nected inside the instrument. Never remove or
loosen this screw!
Recycle
Recycle the mentioned components at their end of
life. Follow local laws.
2.1.1 SAFETY: Before You Begin Installation
This product may constitute a risk to the operator or installation/maintenance
personnel, if used under conditions that must be deemed unsafe, or for purposes
other than the product's designated use, which is described in the introductory
technical chapters of this guide.
DANGER! If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
Before you begin installing and configuring this product, carefully read the fol-
lowing important safety statements. Always ensure that you adhere to any and
all applicable safety warnings, guidelines, or precautions during the installation,
operation, and maintenance of your product.
28
CHAPTER 2 • VersaSync User Manual Rev. 12
2.1 SAFETY
To Next Page
Loading...
