Safran VersaSync - Using Zeroconf; Setting up an IP Address

2.5.1 Using Zeroconf
Connect to the Web UI of your VersaSync unit in these steps:
1. Check the serial number label on the side of the unit, and write down the
last 6 digits of the MAC 0 address: e.g., "0C 00 19". Note that you will use
the same MAC address for either Ethernet port.
2. Connect the VersaSync to a router on your LAN via the ETH connector (see
"Initial Network Setup" on page34).
3. Connect the power supply to the VersaSync unit.
4. On a connected computer, open your web browser and in the URL field
type the following:
versasync-[xxxxxx].local/
where the [xxxxxx] of the hostname are the last six digits of the MAC0
address you copied from the serial number label on the unit.
You should now be prompted for a username and password. The factory
default credentials are:
Username: spadmin
Password: admin123
Note: If you do not have physical access to the unit, you can obtain
the MAC 0 address by accessing VersaSync's CLI via the I/O con-
nector USB port, using e.g., the ifconfig command.
Once you logged into the VersaSync via zeroconf, you can retrieve the DHCP
address for future use:
Navigate to MANAGEMENT: NETWORK > Network Setup. In the Ports
panel, click on the information button next to each Ethernet port. The
popup window will display the assigned DCHP IP address for the selected
port.
See "Setting up an IP Address" below or "Accessing the WebUI" on page37 for
more information.
2.6 Setting up an IP Address
In order for VersaSync to be accessible via your network, you need to assign an
IP address to VersaSync, as well as a subnet mask and gateway, unless you are
40
CHAPTER 2 • VersaSync User Manual Rev. 12
2.6 Setting up an IP Address