1. The GPSD Service panel:
allows you to toggle the service ON or OFF (ON default state)
lists the Service Port
the Gear Icon in the GPSD Service panel allows you to change the Ser-
vice Port information. If your GPSD setup changes and needs to be
reconfigured within your VersaSync, this is where you can reset the
service port.
2. The Actions panel provides an option to restore the default configuration.
3. The Receiver Status panel lists the information required by the GPSD ser-
vice:
Device name
Mode, Time, Position, Track/Speed/Climb, Error Statistics, and Pre-
cision Statistics
All satellites in view and the PRN, Elevation, Azimuth, Signal Strength,
and Usage for each satellite.
GPSD via CLI commands
The following CLI commands are used to control the behavior of GPSD via the
VersaSync CLI:
gpsdserviceportget – Displays the GPSD service port
gpsdserviceportset – Sets the GPSD service port
There are two GPSD utility programs already incorporated into VersaSync;
GPSpipe and CGPS. Both can be used as commands within the CLI to view inform-
ation currently being sent via GPSD. Both commands use CTL + C to stop.
154
CHAPTER 2 • VersaSync User Manual Rev. 12
2.8 Configuring Network Settings
To Next Page
Loading...
