Note: This option only applies to the M8T receiver in your
device, not to SAASM GPS receivers (if equipped).
Caution: If you select a setting that does NOT resurvey, and
subsequently relocate your unit (antenna) by more than
100m, the receiver will NOT detect the new position, and
hence provide an incorrect time.
The following Receiver Dynamics exist:
Land (Resurvey/No Resurvey):
When used with the Mobile Receiver Mode, the receiver is adjusted
for typical dynamic land-based applications.
When used with the Standard Receiver Mode, this setting also will
automatically initiate a resurvey after VersaSync reboots, in order to
account for a possible relocation.
Sea: The receiver dynamics will be optimized for mobile motion pat-
terns typical with marine applications, resulting in greater timing
accuracy, and avoiding premature loss of synchronization.
Air: The receiver dynamics will be optimized for acceleration forces
typically experienced in civil aviation applications.
Stationary (No Resurvey): In Standard Mode, the receiver is set to a
non-dynamic value for stationary applications; there will be no auto-
matic resurvey after a reboot. Hence, should a unit be relocated, you
need to delete its position, thus initiating a new survey.
The following table summarizes the different settings and their inter-
dependencies:
Mode Application Survey?
(Re-)Survey –
When?
Receiver
Dynamics
Mobile
mobile Never Never Land
Air
Sea
204
CHAPTER 3 • VersaSync User Manual Rev. 12
3.3 Managing References
To Next Page
Loading...
