Samsung OfficeServ 7000 Series - Page 178

CHAPTER 2. MMC Programming
2-140
© SAMSUNG Electronics Co., Ltd.
(Continued)
No Option Description
5 NB PLAN
Used to select the type of the Calling Party Number Plan to send to the
network.
UNKNOWN
Unknown numbering plan
ISDN
ISDN numbering plan (CCITT E.163-164)
DATA
Data numbering plan (CCITT X.121)
TELEX
Telex numbering plan (CCITT F.69)
NATIONAL
National standard numbering plan
PRIVATE
Private numbering plan
EXTEN
Local numbering plan
6 CLIR w NUMB
In case of CLIR, the flag can be set to OFF and the CLI number can be
sent.
8 ECT SERVICE
Specifies the ISDN explicit call transfer option as follows:
0. NONE
1. REQ
2. RCV
3. BOTH
(This option may not be available in certain OfficeServ system.)
10 EFWD REROUT
If the option is set to ON, the rerouting message can be sent as
FACILITY type.
12 NO CH BUSY
If BRI line is not available, this line can be set to be busy.
13 CD PLAN Specifies the called party’s numbering plan as follows:
0. UNKNOWN
1. ISDN
2. NATION
14 CD TYPE Specifies the calling party’s number type as follows:
0. UNKNOWN
1. INT. NAT
2. NATIONAL
3. NETWORK
4. SUBSCRIB
5. ABBREV
6. EXTEN
15 TIME SYNC
The time information of system can be updated automatically by BRI
incoming call.
16 DIVERT
In case of using MOBEX trunk, specifies partial rerouting message type
as follows:
0. OFF: Rerouting message can’t be sent.
1. ON: Both diverting and original called number can be sent
2. EXCEPT CD: Only diverting number can be sent.
17 CENTREX
When ISDN trunk has centrex feature, MMC 210 ISDN PROGCON is
set to OFF and the 2nd progress message is incoming, dialed digit can
be sent as ISDN message type.
If the option is set to OFF, dialed digit is sent as DTMF type.