OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-141
OPTIONS FOR BRI PORTS PROGRAMMED AS STATIONS
No Option Description
0 ANY CHANNEL When this option is set to YES, the system will place calls on any free
channel of that BRI if the channel chosen by the user is busy.
(e.g., Preferred channel selection) If set to NO, the user will receive a
busy signal if they attempt to access a busy channel even if the other
channel on that BRI is free. (e.g., Exclusive channel selection)
1 POWER FEED This field determines if power to a BRI access will be supplied. (YES or
NO)
2 ECT SERVICE Specifies the ISDN explicit call transfer option as follows:
0. NONE
1. REQ
2. RCV
3. BOTH
(This option may not be available in certain OfficeServ system.)
CONDITIONS
A BRI card must be installed in the system. Or, the ‘NO BRI CARD’ message is
displayed.
If any changes are made in this MMC, the BRI card that is affected by these changes
must be restarted using MMC 418 in order for the changes to become effective.
DEFAULT DATA
For BRI ports programmed as trunks:
CHANNEL ANY: YES
BRI MODE: P-P DDI
DLSEND: OVERLAP
CLIP TABLE: NONE
NB TYPE: NATIONAL
NB PLAN: ISDN
CLIR w NUMB: OFF
ECT SERVICE: OFF
EFWD REROUT: OFF
NO CH BUSY: OFF
CD PLAN: UNKNOWN
CD TYPE: UNKNOWN
TIME SYNC: OFF
DIVERT: OFF
CENTREX: OFF
For BRI ports programmed as stations:
CHANNEL ANY: YES
POWER FEED: NO
ECT SERVICE: OFF
To Next Page
Loading...
