Samsung OfficeServ 7000 Series - Page 419

OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-381
SIP Carrier Configuration
No Parameter Description Default
00 SIP CARRIER Alphanumeric Name of SIP Carrier
This indicates the ISP carrire name. User can set this
value, but the value doesn’t affect to work of system.
-
01 SIP SERVER Sets ENABLE or DISABLE to interact with external SIP
Server.
DISABLE
02 REGISTERED Displays the OfficeServ’s registration status with the
external SIP server/ SIP carrier.
NO
03 REGIST
ADDR
Designate the Domain Name or the IP Address of the SIP
Registrar. If the domain name value is entered here, the
DNS query is executed, and through this, the IP address
of the Registrar server is acquired.
NONE
04 REGIST PORT Sets the port to use on the Registrar Server. 5060
05 OUT PROXY Designates the Domain Name or the IP Address of the
SIP Server. If the domain name value is entered here, the
DNS query is executed, and through this, the IP address
of the SIP Server is acquired.
NONE
06 ALTER
PROXY
Designates the Alternate Proxy IP Address which is used
if the primary SIP server fails.
0.0.0.0
07 PROXY PORT Sets the port to use on the SIP Server. 5060
08 PROXY NAME Domain name which is set for the user authentication
when using the SIP server
NONE
09 DNS
SERVER1
Designates the IP address of any external name server
(DNS server). The DNS server resolves the SIP server
name to an IP address (This option may not be available
in certain OfficeServ models.)
0.0.0.0
10 DNS
SERVER2
Designate the alternative name server which is used
when the name server designated in the DNS server1
fails. (This option may not be available in certain
OfficeServ models.)
0.0.0.0
11 USER NAME Alphanumeric System username when registering as a
trunking gateway. When empty, system does not send
REGISTER message to interacting Outbound SIP Server.
4100
12 AUTH USER This is the username which is used if the authentication
is required from the SIP server. This is the item which is
used for registering the representative number.
NONE
13 AUTH PSWD This is the password which is used if the authentication is
required from the SIP server. This is the item which is
used for registering the representative number.
NONE
14 REG PER
USER
When interacting with the SIP Server, if this is enabled,
registration is made per user bases. Otherwise, system
will perform representative registration.
DISABLE