Samsung OfficeServ 7000 Series - Page 420

CHAPTER 2. MMC Programming
2-382
© SAMSUNG Electronics Co., Ltd.
(Continued)
No Parameter Description Default
15 SESSION
TIMER
This is the timer value which is used when exchanging
the message periodically to maintain the session if one
session is set. Whether to use the session timer is
determined according to each SIP server. Using the
default value is recommended.
NONE
16 SESSION EXP Indicates the Expire Time in Session Timer. In general,
the value given by the SIP server is used. Using the
default value is recommended.
1800 sec
17 TRK REG EXP The Expire Time exists in periodical registration to the
SIP server. In general, the value given by the SIP server
is used. Using the default value is recommended.
1800 sec
18 ALIVE NOTI Some SIP Servers require SIP UA to send OPTIONS
method simply for link test purpose. When set, system
sends OPTIONS message to the SIP Server.
NONE
19 NOTIFY TIME When ALIVE NOTI is set, NOTIFY TIME decides the
message sending time interval.
1800 sec
20 EXCLUSIVE When Set to Enable, system will only respond specifically
to the enabled SIP server. It will ignore all other SIP
messages not from the specified SIP server.
Disable
21 IMS OPTION When enabled, SIP headers that are commonly used in
IMS environment will automatically be applied.
Disable
22 ASSERTED ID If the value is set to PRIMARY, outbound message’s
FROM header will contain individual station number and
P-Asserted-Identity header will contain primary number
which is assigned by the SIP server.
If the value is set to ALTERNATE, outbound message’s
P-Asserted-Identity header will contain individual station
number and FROM header will contain primary number
which is assigned by the SIP server.
NONE
23 PRIVACY When set, FROM header in outbound SIP message will
have user name of ‘Anonymous’ which hides caller
information. In this case, representative number instead
will be put into P-Asserted-ID header.
Disable
24 SIP PEERING In general cases when making the call by interworking
with the SIP server, the SIP Server IP is used in the
From/To Header, however this is the option used when to
use its own IP of the terminal in case of a specific SIP
server.
DISABLE