OfficeServ 7000 Series Call Server Programming Manual
© SAMSUNG Electronics Co., Ltd.
2-383
(Continued)
No Parameter Description Default
25 CLIP TABLE Refers to SEND CLI NUMBER (MMC 323), which
provides calling party identification when using the MGI
as a SIP gateway.
This provides station ID of the calling station. A single-
digit value corresponding to the desired table in MMC
323 should be entered here. This is only used when
MMC 405 value is null.
1
26 SS TYPE Indicates how SIP call flow will be done; Samsung vs.
Standard. When set to Samsung, system will not follow
standard SIP call flow that is recommended in RFCs, but
instead will initiate Samsung proprietary call flow. Default
value is Standard. This value should remain at default
except for special cases.
Samsung
27 302 RESP This option is used for configuring external call forward
method. During external call forward condition, if this
option is set to Enable, system responds back to the SIP
carrier with a 302 message which will allow the SIP
carrier to handle the call forward. If this option is
disabled, then the OfficeServ system will initiate a second
invite message to the final forward destination.
When OfficeServ handles the forwarding to the final
destination, then more MGI resources will be used. If the
SIP provider supports the 302 method, this option should
Disable
28 DEST TYPE This option selects the field that will be used to specify
the final recipient destination. The field can be either the
TO header or Request URI in the incoming INVITE
message.
To-Header
29 VIRTUAL RBT When enabled, an outbound SIP trunk call will receive
simulated ringback from the OfficeServ as soon as
OfficeServ receives 18x message from the SIP UA.
If disabled, then actual ringback is received from remote
party.
Disable
30 CODEC
NEGO
When disabled, the codec used will be the one selected
in MMC 835 (MGI settings). When enabled, the codec
used for the SIP call will be auto negotiated with the SIP
carrier or remote SIP UA.
DISABLE
To Next Page
Loading...
