CHAPTER 2. MMC Programming
2-384
© SAMSUNG Electronics Co., Ltd.
(Continued)
No Parameter Description Default
31 HOLD RE-INV This option decides whether to use RE-INVITE message
or not in case of HOLD and RESUME. When set to
ENABLE, and pressed Hold button during an active SIP
session, OfficeServ sends RE-INVITE message
indicating it wants to put on hold. If set DISABLE,
however, OfficeServ does not send any message.
This option can be useful especially when interoperating
with a SIP UA which does not understand or allow RE-
INVITE message scheme.
-
32 URI TYPE This field specifies SIP-URI type in SIP messages.
According to SIP standard, this system supports TEL-URI
as well as SIP-URI, which is set by default.
-
33 SIG TYPE This indicates the transport type in SIP message
Signaling. SIP message can be transported either using
UDP or TCP.
(This option may not be available in certain OfficeServ
models.)
-
ENTERING SIP CARRIER, PROXY NAME, USER NAME, AUTH USER, AUTH
PSWD
The characters which are related to VoIP are limited. So it is different to entering special
characters in normal case. Refer to the below.
Volume Up/Down keys
When the character you want appears on the same dial pad key as the previous
character, press the Volume Up button to move the cursor to the right or the
Volume Down button to move the cursor to the left. A space can be entered using
these keys.
To Next Page
Loading...
