Steris Vision 1321 - Modifying a Customized Cycle

6 — Cycle and Control Value Programming
101
Operator Manual
Vision® 1300 Series
920515770_J
5. Select and press name of cycle to be copied for creating new customized cycle. Display shows Select destination
cycle screen.
NOTE: On Select destination cycle screen, press Right arrow to scroll across touch screen to view following
menus.
6. Select and press name of available cycle to be used as new customized cycle.
7. If copied cycle must be modified to suit the use of the newly created custom cycle, proceed as explained in
Section 6.12, Modifying a Customized Cycle .
6.12 Modifying a Customized Cycle
IMPORTANT: If bar code reader (accessory) is present, note that additional bar code tags are available for use with customized
cycle. Available bar code tag numbers must be configured within customized cycle parameters (see Section 6.13, Assigning Bar
Code Tag Numbers (Bar Code Reader Accessory)).
Only certain parameters and values can be programmed for each customized cycle (see ). To modify a customized cycle,
proceed as follows:
1. Access Supervisor mode as explained in Section 6.6, Logging in Supervisor Mode.