8 — Troubleshooting
156
920515770_J
Vision® 1300 Series
Operator Manual
Troubleshooting
8.1 Troubleshooting — Introduction
IMPORTANT: A listing of the Safety Precautions to be observed when operating and servicing this equipment can be found in
Safety Precautions section of this manual. Do not operate or service the equipment until you have become familiar with this
information.
8.2 Troubleshooting – General
WARNING
PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD
Repairs and service adjustments to this equipment must be made only by STERIS or
STERIS-trained service personnel. Repairs and service adjustments performed by
unqualified personnel or installation of unauthorized parts could cause personal injury,
result in improper equipment performance, void the warranty or result in costly
damage. Contact STERIS regarding service options.
WARNING
ELECTRIC SHOCK AND/OR BURN HAZARD
Fasteners and star washers are used to ensure protective bonding continuity. Always
reinstall any star washer which may have been removed during installation or servicing.
Lock building electric supply to OFF and close unit supply valves before performing any
service on the washer/disinfector. Do not service unit unless all utilities have been
properly locked out. Always follow local electrical codes and safety-related work
practices.
WARNING
SLIPPING HAZARD
To prevent slips, keep floors dry. Promptly cleanup any spills or drippage. If detergents
or other chemicals spill, follow safety precautions and handling procedures set forth on
detergent or chemical label and/or Safety Data Sheet (SDS).
This section describes the types of warning messages which may appear on the touch screens and indicates probable
causes.
This section also describes the types of malfunctions which may occur and indicates probable causes.
To Next Page
Loading...
