Steris Vision 1321 - Routine Maintenance; Routine Maintenance - General

7 — Routine Maintenance
116
920515770_J
Vision® 1300 Series
Operator Manual
Routine Maintenance
7.1 Routine Maintenance — Introduction
IMPORTANT: A listing of the Safety Precautions to be observed when operating and servicing this equipment can be found in
Safety Precautions section of this manual. Do not operate or service the equipment until you have become familiar with this
information.
7.2 Routine Maintenance — General
WARNING
PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD
Regularly scheduled routine maintenance, as well as preventive maintenance, are required for safe and
reliable operation of this equipment. Routine maintenance procedures are explained in this manual. For
preventive maintenance, contact STERIS to schedule preventive maintenance or obtain the necessary
Maintenance Manual (P764334-114) if preventive maintenance is done by the Customer.
Repairs and adjustments to this equipment must be made only by STERIS or STERIS-trained service
personnel. Repairs and adjustments performed by unqualified personnel or installation of unauthorized
parts could cause personal injury, result in improper equipment performance, void the warranty or result
in costly damage. Contact STERIS regarding service options.
WARNING
ELECTRIC SHOCK AND/OR BURN HAZARD
Fasteners and star washers are used to ensure protective bonding continuity. Always reinstall any star
washer which may have been removed during installation or servicing.
WARNING
PERSONAL INJURY AND/OR EQUIPMENT DAMAGE HAZARD
Due to the size of the equipment, it may be necessary during installation, repairs or maintenance to
conduct work on TOP of the equipment. Customer is responsible for ensuring that necessary fall
protection safeguards are in place, including those required by applicable safety regulations and
standards such as those promulgated by the Occupational Safety and Health Administration (OSHA).
WARNING
ELECTRIC SHOCK AND/OR BURN HAZARD
Repairs and adjustments to this equipment must be made only by STERIS or STERIS-trained service
personnel. Service personnel must disconnect all utilities to unit before servicing. No one should service
unit unless all utilities have been properly locked out. Always follow local electrical codes and safety-
related work practices.