5 — Operating Instructions
62
920515770_J
Vision® 1300 Series
Operator Manual
5.20 Using Standby Mode — General
Any reservoir that has not been used for more than 24 hours is automatically drained and thermal reservoir
temperature is always kept hot to be ready for the next cycle. To save water, steam or electricity and chemicals, the
washer/disinfector should be put in Standby Mode when it will not be used overnight or for a longer period of time.
All reservoirs will be drained but not filled again until washer is put back in Ready Mode.
5.21 Using Standby Mode When in Ready Mode
1. Display shows Ready screen:
Press Standby/Restore on touch screen. Display shows Standby Confirmation screen:
To Next Page
Loading...
