Steris Vision 1321 - Assigning Bar Code Tag Numbers (Bar Code Reader Accessory)

6 — Cycle and Control Value Programming
104
920515770_J
Vision® 1300 Series
Operator Manual
10. Follow instructions on touch screen to modify all appropriate cycle phases parameters. Parameters that can be
modified are indicated in .
11. Use keyboard to enter desired value within range indicated.
NOTE: On Modify phases screen, press Right arrow to scroll across touch screen to view following menus.
12. Once all modifications are completed, press Close on touch screen until reaching desired screen.
6.13 Assigning Bar Code Tag Numbers (Bar Code Reader Accessory)
If bar code reader (accessory) is present, additional bar code tags are available for use with customized cycles. Bar code
tag numbers are configured as follows:
1. Access Supervisor mode as explained in Section 6.6, Logging in Supervisor Mode.
NOTE: X touch pad returns to previous screen.
2. In Supervisor menu screen, press Cycles on touch screen. Display shows Cycles - Copy/Modify/Bar codes
assignation screen.