4 — Component Identification
32
920515770_J
Vision® 1300 Series
Operator Manual
1. Emergency Stop Pushbutton
.
4.34 Emergency Safety Feature — Emergency Stop Cables
WARNING
PERSONAL INJURY HAZARD
Always verify door bridge is down before entering and exiting washer/disinfector
chamber.
Emergency stop cables are located inside chamber, one on each wall.
In case of an emergency, pull on either cable. Washer/disinfector operation instantly stops, both doors are de-
energized and an alarm is triggered. Manually slide open one of the doors to exit the chamber.
IMPORTANT: To acknowledge an EMERGENCY CABLES alarm, a supervisor code must be entered. Refer to Section 5.24,
Responding to an Alarm.
To Next Page
Loading...
