3 — Installation verification
12
920515770_J
Vision® 1300 Series
Operator Manual
Table 3-2. Prolystica Ultra Concentrate Chemicals Specifications (continued)
Chemical (On-Screen
Identification)
Typical pH Available
Injection Rate
(s) mL/L
[oz./gallon]
Description of Chemical
(PUC Alkaline) 0.4 [1/20]
0.8 [1/10]
product than traditional liquid
detergents.
High-chelating ability and effective on a
wide variety of surgical soils, including
protein, blood and lipids.
Prolystica® Ultra Concentrate
HP Enzymatic Cleaner
NOTE: Used only in
INSTRUMENT cycle
(Instrument Washing option
required).
7.0
0.2 [1/40]
0.4 [1/20]
0.8 [1/10]
Liquid, low-foaming, easy-to-rinse ultra
concentrate using ten times less
product than traditional liquid
detergents.
Fast-acting and effective on a wide
variety of surgical soils, including
protein, blood and lipids. Compatible
with a wide variety of substrates
including soft metals. Non-staining.
Prolystica® Ultra Concentrate
HP Neutral Detergent
7.8
0.2 [1/40]
0.4 [1/20]
0.8 [1/10]
Liquid, low-foaming, easy-to-rinse ultra
concentrate using ten times less
product than traditional liquid
detergents.
Effective on blood, fat, mucous and
other soils, especially orthopedic soils.
Compatible with a wide variety of
substrates including soft metals.
Prolystica® Ultra Concentrate
HP Alkaline Detergent
11.2
0.2 [1/40]
0.4 [1/20]
0.8 [1/10]
Liquid, low-foaming, easy-to-rinse ultra
concentrate using ten times less
product than traditional liquid
detergents.
Effective on blood, fat, mucous and
other hard to remove soils, especially
orthopedic soils. Compatible with a wide
variety of substrates including select
soft metals.
3.9 Using Other STERIS Chemicals
Other STERIS chemicals can also be used for processing loads within the washer/disinfector. Contact STERIS for more
information about chemicals available for use with the Vision 1321 Cart and Utensil Washer/Disinfector, the Vision
1327 Cart and Utensil Washer/Disinfector and the Vision 1330L Cart and Utensil Washer/Disinfector.
When selecting other STERIS chemicals, to achieve optimal performance, the STERIS chemicals selected must meet as
a minimum the specifications listed in Table 3-3.
Refer to Table 6-1,Cycle Description Chart, for more details about the cycles and the parameters within the cycles such as
temperature, injection rate, etc. Use these charts as a reference while processing cycles.
To Next Page
Loading...
