6 — Cycle and Control Value Programming
105
Operator Manual
Vision® 1300 Series
920515770_J
3. Press Bar codes assignation on touch screen. Display shows Bar codes assignation screen.
4. Using slider or arrow on Bar codes assignation screen, locate cycle for which a bar code tag needs to be
assigned.
5. When cycle is located, press Number selection touch pad under cycle name to enter bar code tag number using
alphanumeric keyboard.
6. Enter bar code tag number.
7. Once number has been entered, press Enter to confirm entry.
8. Once all numbers have been assigned, press Close on touch screen until reaching desired screen.
6.14 Supervisor Menu — Machine Setup
NOTE: While scrolling through screens and menus, note the following:
1. Refer to Section 3.2.7, Touch Pads, for complete touch pads description.
2. Press Close on touch screen to return to previous screen.
3. When Enter is not present on touch screen, changes are saved by pressing Close on touch screen while
returning to a previous screen.
To modify washer/disinfector parameters, proceed as follows:
To Next Page
Loading...
