Steris Vision 1321 - Using a Drying Agent for Thermal Rinse Phase; Using an Acid Chemical for DECONTAM Cycle

3 — Installation verification
14
920515770_J
Vision® 1300 Series
Operator Manual
Table 3-3. Other STERIS Chemicals Specifications (continued)
Chemical Typical pH Available
Injection Rate
(s) mL/L
[oz./gallon]
Description of Chemical
Formulated with biodegradable
surfactants.
eSSENTIALS CONCENTRATES
Neutral Detergent
6.0 - 8.0 1 - 8
[1/8 - 1]
Formulated to clean stainless-steel
surgical instruments and other medical
devices.
Low foam. Broad-spectrum substrate
compatibility; including aluminum and
anodized aluminum. Formulated with
biodegradable surfactants.
eSSENTIALS CONCENTRATES
Enzymatic Presoak and
Cleaner
7.5 - 8.5 1 - 8
[1/8 - 1]
Formulated to clean stainless-steel
surgical instruments and other medical
devices.
Low foam. Fast-acting and effective on a
range of soils, including protein, blood,
and lipids. Formulated with
biodegradable surfactants.
3.10 Using a Drying Agent for Thermal Rinse Phase
The following drying agent is recommended to be used for the Thermal Rinse phase:
Table 3-4. Drying Agent For Thermal Rinse
Chemical Typical pH Available
Injection Rate
(s) mL/L
[oz./gallon]
Description of Chemical
Dri 'N Shine® Concentrated
Drying Agent
~ 9.0
0.16 [1/50]
A concentrated liquid drying agent
suitable for use in the final rinse of
washers/disinfectors to lower surface
tension of water to produce spot-free
surfaces.
3.11 Using an Acid Chemical for DECONTAM Cycle
The following acid detergent is recommended to be used for the DECONTAM cycle: