Steris Vision 1321 - Operating Modes - Introduction; Ready Mode; Standby Mode

4 — Component Identification
26
920515770_J
Vision® 1300 Series
Operator Manual
1. Touch Screen
2. Load Side Control Panel
3. Unload Side Control Panel
.
4.20 Operating Modes — Introduction
The control system offers four operation modes: Ready, Cycle, Supervisor and Service. The Ready and Cycle modes are
always available. The Supervisor and Service modes are password-protected.
4.21 Ready Mode
The Ready mode is the default operating mode of the washer/disinfector. No login is required to enter in Ready mode.
The Ready mode allows access to the other operating modes (Cycle, Supervisor and Service).
4.22 Standby Mode
In Ready mode, or while a cycle is in progress, a Standby/Restore button is displayed in the bottom of the screen.