7 — Routine Maintenance
147
Operator Manual
Vision® 1300 Series
920515770_J
7.10 Vision CW Instrument Washing Manifolded Rack Spray Arm Assemblies
WARNING
BURN HAZARD
Allow washer/disinfector to cool down before performing any service on pump,
mechanical components or piping. Surfaces become very hot during washer/disinfector
operation.
WARNING
SLIPPING HAZARD
To prevent slips, keep floors dry. Promptly clean up any spills or drippage. For spills or
drippage of detergents or other chemicals, follow safety precautions and handling
procedures set forth on detergent or chemical label and/or Safety Data Sheet (SDS).
IMPORTANT: Clean only one spray arm to avoid mixing parts.
To clean spray arm assemblies on manifolded rack, proceed as follows:
1. Remove pin securing rotary spray arm assembly to Vision CW Instrument Washing Manifolded Rack.
2. Remove rotary spray arm assembly.
To Next Page
Loading...
