REAR SUSPENSION 3E-9
8) Lower hoist and vehicle in non-loaded condition, tighten
absorber lower bolt (1) and lateral rod body side nut (2) to
specified torque.
Tightening torque
Rear shock absorber lower bolt
(a): 63 N·m (6.3 kg-m, 45.5 lb-ft)
Lateral rod nut (body side)
(b): 100 N·m (10.0 kg-m, 72.5 lb-ft)
9) If equipped with LSPV, check and adjust LSPV spring refer-
ring to “LSPV (Load Sensing Proportioning Valve) Inspection
and Adjustment” in Section 5A and “Brake Fluid Pressure
Test (if equipped with LSPV)” in Section 5.
Bump Stopper
Installation
1) Install bumper stopper.
2) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
Trailing Arm
Installation
1) Install trailing arm (1) to vehicle body and rear axle, referring
to figure for proper installing direction of bolts (2) and then
tighten
nuts (3) temporarily by hand.
NOTE:
Before installing bump stopper apply soap water on it.
A. Vehicle center side
B. Vehicle outside
To Next Page
Loading...
