0A-2 GENERAL INFORMATION
How to Use This Manual
1) There is a “Table of Contents” on the third page of this manual, whereby you can easily find the section that
offers the information you need. Also, there is a “Contents” on the first page of each section, where the main
items in that section are listed.
2) Each section of this manual has its own pagination. It is indicated at the top of each page along with the Sec-
tion name.
3) The special tool usage and torque specification are given as shown in the figure.
4) A number of abbreviations and symbols are used in the text. For their full explanations, refer to “Abbrevia-
tions and Symbols May Be Used In This Manual” in this section.
5) The SI, metric and foot-pound systems are used as units in this manual.
6) “Diagnosis” are included in each section as necessary.
7) At the end of each section, there are descriptions of “Special Tool”, “Required Service Material” and “Tight-
ening Torque Specification” that should be used for the servicing work described in that section.
To Next Page
Loading...
