MAINTENANCE AND LUBRICATION 0B-13
Fuel Tank Inspection
Check fuel tank damage, cracks, fuel leakage, corrosion and tank
bolts looseness.
If a problem is found, repair or replace.
PCV Valve Inspection
Check crankcase ventilation hose and PCV hose for leaks, cracks
or clog, and PCV valve for stick or clog. Refer to “PCV valve”
under “PCV System Inspection” of Section 6E1 or 6E2 for PCV
valve checking procedure.
Fuel Evaporative Emission Control System
Inspection
1) Visually inspect hoses for cracks, damage, or excessive
bends. Inspect all clamps for damage and proper position.
2) Check EVAP canister for operation and clog, referring to
“EVAP Canister” under “EVAP Control System Inspection” in
Section 6E1 or 6E2.
If a malfunction is found, repair or replace.
Brake Discs and Pads (Front) Inspection
1) Remove wheel and caliper but don’t disconnect brake hose
from caliper.
2) Check front disc brake pads and discs for excessive wear,
damage and deflection. Replace parts as necessary. For
details, refer to “Front Disc Brake Pad Inspection” and “Front
Brake Disc Inspection” in Section 5B.
Be sure to torque caliper pin bolts to specification.
To Next Page
Loading...
