7B1-202 AUTOMATIC TRANSAXLE (M13 ENGINE)
• Install torque converter aligning grooves (1) of torque con-
verter and projection (2) of oil pump drive gear.
• Install torque converter, using care not to damage oil seal of
oil pump.
• After installing torque converter, check that distance “a” is
within specification.
Torque converter installing position
“a”: More than 19.9 mm (0.783 in.)
• Check torque converter for smooth rotation.
• Apply grease around cup at the center of torque converter.
“C”: Grease 99000-25010
CAUTION:
• Before installing converter, make sure that its pump
hub portion is free from nicks, burrs or damage which
may cause oil seal to leak.
• Be very careful not to drop converter on oil pump gear.
Damage in gear, should it occur, may cause a critical
trouble.
1. Torque converter
2. Flange nut
3. Torque converter housing
4. Cup
To Next Page
Loading...
