7B1-172 AUTOMATIC TRANSAXLE (M13 ENGINE)
7) Remove temperature sensor clamp (1).
Assembly
Reverse disassembly procedure for assembly, noting following
points.
• Shift solenoid valve-A and -B are identical
• After applying A/T fluid to new O-rings, fit them to solenoid
valves, then install solenoid valves to valve body.
• Tighten solenoid valve bolts to specified torque
Tightening torque
Solenoid valve bolt
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
Torque converter housing
Disassembly
1) Remove fluid reservoir RH plate (1) and lubrication tube
clamp (2).
Bolt Length “a” Pieces
A (1) 49 mm (1.93 in.) 5
B (2) 20 mm (0.79 in.) 1
To Next Page
Loading...
