GENERAL INFORMATION 0A-11
Precaution in Servicing Full-Time 4WD Vehicle
This full-time 4WD vehicle can not be converted to 2WD manually.
Observe the following caution in servicing. Otherwise, front wheels drive rear wheels or vise-versa and
vehicle accidents, drivetrain damage and personal injury may result.
• Never perform any of the following types of service
work.
[A]: Testing with 2-wheel chassis dynamometer, speed-
ometer tester or brake tester.
[B]: Driving front wheels, which are jacked up.
[C]: Towing under the condition where either front or
rear wheels can not rotate.
• When testing with 2-wheel chassis dynamometer,
speedometer tester or brake tester, be sure to make the
vehicle as front wheel drive by removing propeller shaft.
• When using On-vehicle type wheel balancing equipment
(1), be sure to jack up all four wheels, off the ground
completely and support vehicle with safety stands (2).
Be careful of the other wheels, which will rotate at the
same time.
• This vehicle should be towed under one of the following
conditions:
– With all wheels on a flatbed truck.
– With front or rear wheels lifted and a dolly under the
other wheels.
To Next Page
Loading...
Need help?
General
