AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-141
One-way Clutch No.1 Assembly
1) Install one-way clutch No.1 assembly (2) to rear planetary
sun gear subassembly (1).
2) Securing rear planetary sun gear subassembly, ensure that
one-way clutch No.1 assembly rotates only in one direction.
If the one-way clutch rotates in both directions or it does not
rotate in either direction, replace it with new one.
Disassembly/Assembly of Subassembly
CAUTION:
• Keep component parts in group for each subassembly and avoid mixing them up.
• Clean all parts with cleaning solvent thoroughly and air dry them.
• Use kerosene or automatic transaxle fluid as cleaning solvent.
• Do not use wiping cloths or rags to clean or dry parts.
• All oil passages should be blown out and checked to make sure that they are not obstructed.
• Keep face and eyes away from solvent spray while air blowing parts.
• Check mating surface for irregularities and remove them, if any, and clean it again.
• Soak new clutch discs and brake discs in transaxle fluid for at least 2 hours before assembly.
• Replace all gaskets and O-ring with new ones.
• Apply automatic transaxle fluid to all O-rings.
• When installing seal ring, be careful so that it is not expanded excessively, extruded or caught.
• Replace oil seals that are removed and apply grease to their lips.
• Before installing, be sure to apply automatic transaxle fluid to sliding, rolling and thrusting surface
of all component part. Also after installation, make sure to check each part for proper operation.
• Always use torque wrench when tightening bolts.
To Next Page
Loading...
