FRONT DRIVE SHAFT (G10/M13 ENGINES) 4A-3
Front Drive Shaft Assembly Removal and
Installation
Removal
1) Undo caulking (1) and remove drive shaft nut (2).
2) Loosen wheel bolts.
3) Hoist vehicle.
4) Remove wheel.
5) Drain transaxle oil as follows.
• For M/T model with G10 engine
Refer to “Oil Change” in Section 7A of the Service Manual
mentioned in the FOREWORD of this manual.
• For M/T model with M13 engine
Refer to “Transaxle Oil Change” in Section 7A2.
• For A/T model
Refer to “Fluid Change” in Section 7B1.
6) Drain transfer oil referring to “Oil Change” in Section 7D of
the Service Manual mentioned in the FOREWORD of this
manual, if equipped.
7) Remove tie-rod end nut.
8) Disconnect tie-rod end (1) from steering knuckle (2) by using
puller (3).
CAUTION:
To prevent the breakage of boots, be careful not to dam-
age the boots when removing drive shaft assembly.
To Next Page
Loading...
