4A-4 FRONT DRIVE SHAFT (G10/M13 ENGINES)
9) Pull out drive shaft joint (2) as follows.
• For left side of all model and right side of G10 engine model
Using tire lever (1), pull out drive shaft joint (2) so as to
release snap ring fitting of joint spline at differential side.
• For right side of 2WD model with M13 engine
Using plastic hammer (3), drive out drive shaft joint (2) so as
to release snap ring fitting of joint spline at center shaft.
• For right side of 4WD model with M13 engine
Using plastic hammer, drive out drive shaft joint (2) so as to
release snap ring fitting of joint spline at transfer side.
10) Remove two stabilizer mount brackets from vehicle body.
11) Disconnect front suspension control arm ball joint stud from
steering knuckle (1) by pushing down stabilizer bar after
removing ball joint bolt (2).
12) Remove drive shaft assembly.
13) For vehicle with center shaft, remove center bearing support
bolts (3) and remove center bearing support (2) with center
shaft (1) from differential side gear.
[A]: Left side of all model and right side of G10 engine model
[B]: Right side of 2WD model with M13 engine
[C]: Right side of 4WD model with M13 engine
2
1
3
2
1
To Next Page
Loading...
