6A2-16 ENGINE MECHANICAL (M13 ENGINE)
8) Lift valve by turning crankshaft counterclockwise (in opposite
direction against above Step 4) and remove special tool.
Special tool
(A): 09916-67020 or 09916-67021
9) Install camshaft housing (1) and tighten bolts to specified
torque.
Tightening torque
Camshaft housing bolt
(a): Tighten 11 N·m (1.1 kg-m, 8.0 lb-ft)
by the specified procedure.
10) Check valve clearance again after adjusting it.
11) After checking and adjusting all valves.
12) Install cylinder head cover referring to “Cylinder Head Cover
Removal and Installation” in this section.
On-Vehicle Service
Air Cleaner Element Removal and Installation
Removal
1) Open air cleaner case (1) by unhooking its clamps (2).
2) Remove air cleaner element from case.
Installation
Reverse removal procedure for installation.
1. Tappet
2. Camshaft
(A)
2
1
1
2
To Next Page
Loading...
