ENGINE COOLING (M13 ENGINE) 6B2-3
Coolant
The coolant recovery system is standard. The coolant in the radiator expands with heat, and the coolant is over-
flowed to the reservoir.
When the system cools down, the coolant is drawn back into the radiator.
The cooling system has been filled with a quality coolant that is a 50/50 mixture of water and ethylene glycol
antifreeze.
This 50/50 mixture coolant solution provides freezing protection to –36°C (–33°F).
• Maintain cooling system freeze protection at –36°C (–33°F) to ensure protection against corrosion and loss
of coolant from boiling. This should be done even if freezing temperatures are not expected.
• Add ethylene glycol base coolant when coolant has to be added because of coolant loss or to provide added
protection against freezing at temperature lower than –36°C (–33°F).
Anti-freeze proportioning table
Coolant capacity
NOTE:
• Alcohol or methanol base coolant or plain water alone should not be used in cooling system at any
time as damage to cooling system could occur.
• Coolant must be mixed with demineraled water or distilled water.
For M/T model For A/T model
Freezing temperature
°C –36 –36
°F –33 –33
Anti-freeze/Anti-corrosion
coolant concentration
%50 50
Ratio of compound
to cooling water
Itr. 2.80/2.80 2.70/2.70
US pt. 5.97/5.97 5.76/5.76
Imp pt. 4.93/4.93 4.75/4.75
For M/T model For A/T model
Engine radiator and heater 5.0 liters (10.67/8.80 US/lmp. pt.) 4.8 liters (10.24/8.45 US/lmp. pt.)
Reservoir 0.6 liters (1.28/1.06 US/lmp. pt.) 0.6 liters (1.28/1.06 US/lmp. pt.)
Total 5.6 liters (11.94/9.86 US/lmp. pt.) 5.4 liters (11.52/9.51 US/lmp. pt.)
To Next Page
Loading...
