7C-8 CLUTCH (G10/M13 ENGINES)
Clutch cover
1) Check diaphragm spring (1) for abnormal wear or damage.
2) Inspect pressure plate (2) for wear or heat spots.
3) If abnormality is found, replace clutch cover. Do not disas-
semble it into diaphragm spring and pressure plate.
Flywheel
Check surface contacting clutch disc for abnormal wear or heat
spots. Replace or repair as required.
INSTALLATION
1) Install flywheel (1) to crankshaft and tighten bolts (2) to spec-
ified torque.
Special tool
(A): 09924-17810
Tightening torque
Flywheel bolt (M13 engine) (a): 70 N·m (7.0 kg-m, 50.5 lb-ft)
Flywheel bolt (G10 engine) (a): 76 N·m (7.6 kg-m, 54.5 lb-ft)
2) Using special tool, install input shaft bearing to flywheel.
Special tool
(B): 09925-98210
NOTE:
Before assembling, make sure that flywheel surface and
pressure plate surface have been cleaned and dried thor-
oughly.
To Next Page
Loading...
