5B-2 FRONT BRAKE
On-Vehicle Service
Front Disc Brake Pad
Installation
1) Install pads (1).
CAUTION:
Lubricate parts as specified. Do not use lubricated shop air on brake parts as damage to rubber com-
ponents may result. If any component is removed or line disconnected, bleed the brake system.
Replace pads in axle sets only. The torque values specified are for dry, unlubricated fasteners.
1. Wheel bolt Tightening torque
NOTE:
• When installing brake pad, make sure that its tapered
side is positioned upward (A) as shown in figure.
• Install pad with sensor (2) to vehicle center side on
right wheel brake.
A: Upper side
B: Lower side
To Next Page
Loading...
