EasyManua.ls Logo

Suzuki Wagon R Plus RB310 - No Lock-Up Occurs

Suzuki Wagon R Plus RB310
846 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7B1-44 AUTOMATIC TRANSAXLE (M13 ENGINE)
Diagnostic Flow Table A-2: No Lock-Up Occurs
System Description
TCM turns TCC solenoid OFF under any of the following conditions.
Brake light switch is turned ON. (Brake pedal is depressed)
Engine coolant temperature is less than 60°C (140°F).
Throttle opening is as much as 0%.
TCM detects the following DTCs.
P0705/P0707/P0712/P0713/P0717/P0722/P0785/P0962/P0963/P0973/P0974/P0976/P0977/P1701/
P1702/P1703/P2769/P2770
Troubleshooting
WARNING:
When performing a road test, select a place where there is no traffic or possibility of a traffic acci-
dent and be very careful during testing to avoid occurrence of an accident.
Road test should be carried out with 2 persons, a driver and tester, on a level road.
Step Action Yes No
1Was A/T System Check performed? Go to Step 2. Go to A/T System
Check.
2 Check DTC.
Is DTC P0705, P0707, P0712, P0713, P0717,
P0722, P0785, P0962, P0963, P0973, P0974,
P0976, P0977, P1701, P1702, P1703, P2769
and/or P2770 detected?
Perform DTC flow table to
repair and retry.
Go to Step 3.
3 Perform running test under the following condi-
tions and measure voltage between terminal
E13-5 of TCM connector and ground.
O/D OFF switch is turned OFF. (O/D OFF
lamp does not light)
Engine coolant temperature is in normal
operating temperature.
Select lever is in D range.
Brake pedal is released.
Drive vehicle with 4th gear and TCC ON
condition referring to Automatic Gear Shift
Diagram in this section.
Is terminal voltage about 9 14 V?
Faulty TCC solenoid
valve, circuit or transaxle.
WHT/BLU circuit
shorted to ground.
If wire is OK, go to step 4
4 Brake light switch signal inspection.
With ignition switch ON, check voltage between
terminal E21-9 of ECM connector and
ground.
Brake pedal is released: 0 1 V
Brake pedal is depressed: 8 14 V
Is result as specified?
Substitute a known-good
TCM and recheck.
Mis-adjusted brake light
switch, faulty brake light
switch or its circuit.
If OK, substitute a known-
good TCM and recheck.

Table of Contents

Related product manuals