AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-93
5) Check fluid level referring to “Fluid Level Check at Room
(Cold) Temperature (Cold Check)” and “Fluid Level Check at
Normal Operating (Hot) Temperature (Hot Check)” in this
section.
Automatic transaxle fluid
An equivalent of DEXRON
®
-III
Automatic transaxle fluid capacity
When draining from drain plug hole:
3.3 liters (6.97/5.81 US/Imp. pt.)
When overhauling:
5.6 liters (11.83/9.86 US/Imp. pt.)
A/T fluid cooler hoses
The rubber hoses for the A/T fluid cooler should be replaced at
specified interval. When replacing them, be sure to note the fol-
lowing.
• to replace clamps at the same time
• to insert hose as far as its limit mark
• to clamp clamps securely
1. Fluid level gauge
2. “FULL HOT” mark
3. “LOW HOT” mark
4. “FULL COLD” mark
5. “LOW COLD” mark
1. Radiator
2. Inlet hose (Outlet from A/T fluid cooler)
3. Outlet hose (Inlet to A/T fluid cooler)
To Next Page
Loading...
